How to Import The Pool

The first thing to keep in mind is that for the pool to be properly imported into your 3d design you will have to create 4 different levels, each one with a different height and depth.

First level:

The most important level that we will call Pool, (always take as reference the level of the sea or the level altitude and depth 0), must have as elevation -2.00 meters, floor thickness of the ground 0.12 meters and as height 2, 50 meters

The next level we call medium should have as elevation -0.50 meters, floor thickness 0.001 meters and height 2.50 meters.

Level 3, we do not need to create, since we are referring to sea level, but we must take into account that we are talking about a house with walls of 2.50 meters high, which would be what should be measured. maximum height of this level as well as that of all other levels. Remember that if your house has the highest or lowest walls, you should change the height levels mentioned in each level of this guide as same of the ground thickness and it elevation of 0.12 meters.

And finally we must create the level of the Deck, which will be the highest of all and must have as elevation 0.12 meters, ground thickness 0.12 meters and height 2.50 meters.

Once we have all the levels ready, we will go to the pool level, that is, the first and deepest of the levels created and just at that level, we will import the pool file which will fit perfectly in all levels according to its level and from a general view showing all the levels will be its water a few cm below the level 0 as well as its edges a few cm above the surface, as the pools should really be.

JPL Mods - We try to do our best, but don t espect perfection
https://jping3d.wixsite.com/jpst


